Do we have curdepth, maxdepth,maxmsgl attributes for Alias Queue?
It can be used in Communicating with queue managers inside the cluster from an external queue manager(not in cluster) through a gateway queue manager (which is shared in the cluster).
We use alias queue for.
Novice, joined:, posts: 21, hi All, I want to dvd shrink 3.2 for windows xp use queue manager alias.Define qremote (aliasqmgr) rqmname(realqmgr) rname blank rname means the remote queue definition doesn't point to a queue in another queue manager.And a sender channel which picks up the message from the transmission queue associated with this remote queue would be required to transfer the message from QMB to QMC where its actually destined.At the local queue manager there is a queue manager alias definition like this: define qremote (yourqm) rqmname(realqm) This shows financial account books pdf that the real queue manager to be used, when an application puts messages to queue manager yourqm, is realqm.And you can't put to a queue definition that doesn't exist on QM1.No changes take place if you do not provide parameters.From the transmission queue, message will reach the destination queue manager.If pointed, what will be the reason code you will be getting?WebSphere MQSeries supports this option.Exceeding the operating-system limit results in a communication failure.Sender channel to QMC Qmgr:.QMC.RSS Feed - WebSphere MQ Support.Below are the steps and commands.Back to top pshan81 Posted: Fri Aug 08, 2008 4:39 am Post subject: Acolyte Joined: Posts: 72 I am also exploring queue manager alias.At the local queue manager there is a queue manager alias definition like this: define qremote (yourqm) rqmname(realqm)This shows that the real queue manager to be used, when an application puts messages to queue manager yourqm, is realqm.So without any other configuration in place, ideally the messages would end bitdefender 2012 full version with key up in dead letter queue of QMB.The explicit naming of the qmgr at mqopen causes the local qmgr to NOT perform name resolution.
Thus i created QM1(yourqm) QM2(realqm) and wanted to send messages from QM1 to QM2.
However, you should only run these tasks through the corresponding resource models.